Ana içeriğe git

Konu: PIC programlama yardım (97 Kez okunmuş)

  • 32-bit
  • [*]
PIC programlama yardım
Aşağıdaki programa 2 küçük ekleme yapmak istiyorum ama başaramadım abilerim bi el atarmısınız
-tümü çıkış
-tüm çıkışlar 0
-tüm çıkışlar 1
-0. ve 2. biti söndür
-1. ve 3. biti söndür
-2. ve 3. biti yak bekle.



HELLOWORLD

/**
 *************************************************************************
 *  Lesson 1 - "Hello World"
 *************************************************************************
 * NOTE: See Low Pin Count Demo Board User's Guide for Lesson Information
 *************************************************************************
 *
 *  The LEDs are connected to input-outpins (I/O) RC0 through RC3. First, the I/O pin
 *  must be configured for an output. In this case, when one of these pins is driven high
 *  (RC0 =  1 ), the LED will turn on. These two logic levels are derived from the power pins
 *  of the PIC MCU. Since the PIC device?s power pin (VDD) is connected to 5V and the
 *  source (VSS) to ground (0V), a '1' is equivalent to 5V, and a '0' is 0V.
 *
 *
 *  This turns on DS1 LED on the Low Pin Count Demo Board.
 *
 *  PIC: 16F1829
 *  Compiler: XC8 v1.10
 *  IDE: MPLABX v1.50
 *
 *  Board: PICkit 3 Low Pin Count Demo Board
 *  Date: 6.1.2012
 *
 */

#include <xc.h>                            //PIC hardware mapping

//config bits that are part-specific for the PIC16F1829
#pragma config FOSC=INTOSC, WDTE=OFF, PWRTE=OFF, MCLRE=OFF, CP=OFF, CPD=OFF, BOREN=ON, CLKOUTEN=OFF, IESO=OFF, FCMEN=OFF
#pragma config WRT=OFF, PLLEN=OFF, STVREN=OFF, LVP=OFF

    /* -------------------LATC-----------------
     * Bit#:  -7---6---5---4---3---2---1---0---
     * LED:   ---------------|DS4|DS3|DS2|DS1|-
     *-----------------------------------------
     */

                                            //Every program needs a `main` function
void main(void) {
    TRISCbits.TRISC0 = 0;                   //using pin as output
    LATC = 0;                               //clear all pins to 0
    LATCbits.LATC0 = 1;                     //turn ON the LED by writing to the latch
    while(1) continue;                      //sit here forever doing nothing, think "while(true), continue in this loop"